Repair
Manual Home
Introduction
Guiding Principles
Setting up the Area
Toolbox
Parts of a book
Practical Guidelines
Identifying Repairable Materials
Glossary
Bibliography
Acknowledgements
Your Comments
Self-Closing Wrapper
Cleaning
Torn pages
Tip in a Page
Hinge Repair
Corner Repair
Sewing a Single Signature
Spine Repair
Air Dry Method
Hinge Tightening
Wet Books--The Air Dry Method
This procedure is appropriate for handling one or two wet books. See the Dartmouth College Library Disaster Manual for handling of wet materials on a large scale. Ideally, wet books should be freeze dried then treated. This procedure outlines what to do when the book is not totally soaked and/or freezing is not practical. Wet books that dry closed, or are not treated within six hours of becoming wet, will almost always need to be discarded. The blocking agent used in processing paper acts as an adhesive when wet. The book will probably dry as a solid block.
Suggested Equipment & Supplies:
Procedures:
- Using blotter paper or paper towels, blot as much water from the book as possible. Be careful not to rub either the cover or the wet pages.
- Stand the book on its tail and fan open the pages. If possible dry the book in this position in the sunlight or with the use of a fan. Alternatively, dry the book away from a direct heat source, but in a warm dry area. The more quickly the book dries the less cockling (rippling) will occur.
- If after drying the cover is warped, place the book between two press boards and place in a book press for several days.
- In all likelihood a wet book that has been air dried will never look as good as it once did.
){kind=link}
){kind=link}
){kind=link}
){kind=link}
){kind=link}
){kind=link}